- Check passivation of all grades of stainless steel
- Monitor passivation bath and procedure
- Detect lost passivation in service
- Corrosion troubleshooting
- Satisfy your contract requirements
- ASME BPE 2009
- Fast and easy to use
- Portable, lightweight, battery operated
- Non-destructive passivation testing
- Easy to read digital display
- Safe - no hazardous chemicals
- Certificate of Calibration - traceable to NIST
A Significant Advance in Passivation Testing.
Passive stainless steel is not reactive with its environment. It is non-corroding. The passivation bath, usually nitric acid, cleans off surface free iron which causes rust spots and conditions the surface for the spontaneous formation of protective surface oxides. In effect, an equipotential surface is formed by passivation. The surface free iron can come from various metal working and polishing steps. To eliminate these rust spots on stainless steel, testing for complete passivation is essential, and in most cases, an integral part of industrial and government contracts.
Up to now passivation verification consisted of the old-fashioned clumsy copper sulfate or ferroxyl tests or the lengthy and complicated humidity and salt spray testing. But in selecting the Passivation Tester 2026 you've chosen. a rapid response method for your verification demands. The ASME BPE 2009 and the Federal Spec QQ-P-35C approved this surface corrosion potential measurement as a method of checking passivation, so the Passivation Tester 2026 can be used with complete confidence .
The 2026 is a portable, light-weight instrument measures the corrosion tendency of the surface of stainless steels. It detects surface free iron through a galvanic process which is measured as a voltage. There is no size limitation to the test piece. A typical test, taking only 1-2 seconds, is simple: Electrical contact is made between a test piece through a moist pad. Then the sensitive Passi-Probe is pressed into the pad to complete the circuit and the cell voltage appears on the digital meter.
This measurement can be repeated over the surface of the test part and at sensitive spots, such as seams and welds. Values for passive and non-passive readings are included in the instructions and a standard 304 stainless steel coupon is provided for test comparison and instrument check-out. Samples reading non-passive can be passivated by running them through the passivation bath and then retested. The Passivation Tester 2026 can be used with all chromium containing stainless steels such as 300 and 400 series and the precipitation-hardened steels such as 17-4, 15-5, 17-7 and so on. Because no training is necessary the Passivation Tester 2026 can be used successfully by non-technical personnel.
A passive stainless steel standard is included in the kit.
- Part No. 2026
- Shipping Weight: 4lbs